• On Combine
• Combine a truck load and unload combine & cart onto truck.
• On Display
• Crop Setup Box > Press Start
• On Combine
• Combine a truck load
• On Display
• Crop Setup Box > Press Stop
• On Combine
• Unload combine & Cart onto truck
• Send Truck to scales for Net weight
• On Display
• Crop Setup Box > Press 'Actual lbs'
•  Enter Net weight and Save
• Press Ok to accept the new crop constant.

Additional info:

By combing a truck load before starting the Crop Setup process, you only have to unload what naturally flows out of the augers. This eliminates the need to sweep the combine and cart out at the beginning and end of the calibration process.

Upon pressing 'Stop' and unloading the combine, you can continue combing, and enter in the actual weight when ever the driver get it to you.

Upon completing setup, ever field made active there after, will have this crop constant applied to it.

Crop constant should be tween 0.9 and 1.1.

If you wish to re-calibrate the mass flow sensor later in the season, use Load True Up or Field Total True Up.

Back to YieldSense Operations