Calibrating Header Height

 
 
  • ​On Display
    •  Setup > Equipment > Combine Heads > Harvesting Height
  • On Combine
    • Raise the Header slightly above the highest you would cut in the field. 
  • On Display
    • Press set button (middle right)
    • Save/Load > Update Saved Combine Head > Yes (to configure confirmation) > Ok (to update successfully)

Additional info:

If the field has some topography and you may have to lift the header to get through a dip, you will want lift the head above this height when setting Harvesting Height

Back to YieldSense Operations