• On Display (when pass to pass maps are not lining up)
• • Observe if the map needs to be shifted closer or further from the combine 
• If adjusting is needed
• • Setup > Systems
  • • Select Flow Sensor when adjusting the yield map
    • • Lower the number to shift closer to the combine
      • Increase the number to shift further from the combine
    • Select Moisture Sensor when adjusting moisture map
    • • Lower the number to shift closer to the combine
      • Increase the number to shift further from the combine
        
• Observe the map after a full round to see if further adjusting is needed
• If adjusting is needed, follow the above steps
• When the lag times are correct save the combine config
• • Setup > Equipment > Save / Load > Updated Saved Combine

Additional info:

Best to adjust in small increments or .2 to not over correct.

Back to YieldSense Operations